Technical data

Configuration M203
12
Gefen HDMI Switcher 4x2, 4x1
Switcher 6x2
Control software for the HDMI
Switcher from the Gefen Company
(www.gefen.com)
The HDMI inputs on the HDMI
switcher are activated, dependant
on the M51/ M219 source. If there
is no assignment, the HDMI input
that was last selected remains
active. Setting is done on page #2
in the M203 Setup
Product features:
- 4 HDMI inputs (4x1,4x2)
- 6 HDMI inputs (6x2)
A crossed Sub-D cable is
required for the transmission.
Connection type: Plug-Plug
For this reason, you should use
the enclosed crossover adapter
with the supplied Revox 1:1
cable.
9-Pol ⇒ 9-Pol
Pin 2 ⇒ Pin 3
Pin 3 ⇒ Pin 2
Pin 5 ⇒ Pin 5
Max. cable length RS232: 10 m
Gefen products are freely
available through specialist retail
outlets.
Sharp TV (ATV, DTV)
Control software for the Sharp
televisions. A serial Sub-D cable
(1:1) is required for the
transmission.
Connection type: Plug - Socket
For this reason, you should use
the enclosed gender adapter
with the supplied Revox cable.
9-pin ⇒ 9-pol
pin 5 ⇒ pin 5
pin 2 ⇒ pin 2
pin 3 ⇒ pin 3
Note: The serial interface
(RS232) of the TV is not yet
configured for control by an
external device. There is the
need of an initial
commissioning of it. Please
follow the instructions on
page 13.
Max. cable length RS232: 10 m