Instruction manual

FS 240, FS 240 R
English
29
N Circular saw blades should "hover"
about 20 cm (8 in) above the
ground.
The correct floating position is obtained
as follows:
Balance the unit
N Loosen the screw (3).
N Move the carrying ring (2) up or
down the drive tube – tighten the
screw moderately – let the unit go
and wait until is its balanced – then
check the floating position.
When the correct floating position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Detaching the machine from the
harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing off the machine in an
emergency
WARNING
The machine must be quickly thrown off
in the event of imminent danger. To
throw off the machine, use the
procedure described under "Detaching
the machine from the harness". Practise
removing and putting down the machine
as you would in an emergency. To avoid
damage, do not throw the machine to
the ground when practising.
Controls
Version with Bike Handle
1 Throttle trigger lockout
2 Throttle trigger
3 Momentary contact stop switch with
Run and Stop positions. Press the
stop switch (…) to switch off the
ignition – see "Function of stop
switch and ignition system".
002BA389 KN
3
2
002BA390 KN
1
2
1
2
002BA391 KN
Starting / Stopping the
Engine
1
002BA483 KN
2
3