Instruction manual

FS 240, FS 240 R
English
39
Balancing
N After resharpening about 5 times,
check the cutting attachment for
out-of-balance on a STIHL balancer
(special accessory) or have it
checked by a dealer and re-
balanced as necessary – STIHL
recommends a STIHL servicing
dealer.
Adjusting the Throttle Cable
The throttle cable can be adjusted only
when the machine is properly
assembled. The control handle must be
in the normal operating position.
If the following adjustments do not
produce the required result, have your
servicing dealer repair the machine.
STIHL recommends a STIHL servicing
dealer.
Machines with Bike Handle
Checking adjustment of throttle cable
Error: Engine speed increases when
only the throttle trigger is depressed.
N Start the engine.
N Depress the throttle trigger (2) – do
not press down the throttle trigger
lockout (1).
If the engine speed increases or if the
cutting attachment rotates, the throttle
cable has to be adjusted.
N Shut down the engine.
Adjusting the Throttle Cable
N Depress the throttle trigger lockout
(1) and the throttle trigger (2) as far
as stop and hold them in that
position.
Apply only sufficient pressure to hold the
levers against their stops.
N Rotate screw in throttle trigger 1/2
turn counterclockwise.
N Release the throttle trigger and
throttle trigger lockout.
N Start the engine and check the
adjustment.
N Shut down the engine and repeat
adjustment if necessary.
Models with Loop Handle
N Use a suitable tool to push the slide
to the end of the slot (see
illustration).
Inspection and Maintenance
by User
1
6BA025 KN
2
002BA455 KN
002BA163 KN