Specifications

SPEC No.
LC99213A
MODEL No.
LM10V332
PAGE
25
14)
This specification describes
display quality in case of no gray scale. Since display quality can be
affected by gray scale methods, display quality shall be carefully evaluated for the usability of
LCD module in case gray scale is displayed on the LCD module.
15)
The module should be driven according to the specified ratings to avoid permanent damage.
DC voltage drive leads to rapid deterioration of LC, so ensure that the drive is alternating
waveform by continuous application of the signal M. Especially the power ON/OFF sequence
shown on Page 21 should be kept to avoid latch-up of drive LSI and application of DC voltage to
LCD panel
16)
It is a characteristic of LCD to maintain the displaying pattern when the pattern is applied for a
long time.(Image retention)
To prevent image retention, please do not apply the fixed pattern for along time by pre-installing
such programs at your side.
17)
This phenomenon (image retention) is not deterioration of LCD. If it happens, you can remove it
by applying different patterns.
18)
CCFT backlight should be kept OFF during VDD is “L” level.
11. Applicable inspection standard
The LCD module shall meet the following inspection standard :
１
S-U-014 S-U-035
WARNING
Don’t use any materials which emit following gas from epoxy resin (amines’ hardener) and
silicone adhesive agent (dealcohol or deoxym) to prevent change polarizer color owing to gas.