Instruction manual

MS 362, MS 362 C
English
29
N Push the hand guard (1) forwards –
the saw chain is blocked
N Simultaneously press the throttle
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position choke shutter closed l
– if engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position starting acceleration n
– if engine is warm (once the engine
has been running for approx. one
minute)
N Hold and start the chain saw
When the engine has turned over for the
first time
N Move the Master Control lever (1) to
the position starting acceleration n
N Press the button on the
decompression valve
N Hold and start the chain saw
Once the engine is running
N Press the throttle trigger lockout and
blip the throttle trigger (2); the
Master Control lever (1) jumps to
the operating position F and the
engine begins to idle
N Pull the hand guard toward the
handlebar
The chain brake is released – the chain
saw is ready for use.
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
At very low outside temperatures
N let the engine warm up briefly with
the throttle slightly open
N if necessary, configure for winter
operation, see "Winter Operation"
Switch off engine
N Move the Master Control lever to the
stop position 0
If the Master Control lever was moved
from the position starting
acceleration n to the stop position 0 –
afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
1
4
3
2
0001BA021 KN
0
1
0001BA022 KN
STOP
0
1
2
0001BA023 KN
STOP
0
001BA186 KN