Instruction manual

MS 362, MS 362 C
English
31
Always slacken off the chain again after
finishing work. The chain contracts as it
cools down. If it is not slackened off, it
can damage the crankshaft and
bearings.
Short-term storage
Wait for engine to cool down. Keep the
machine with a full tank of fuel in a dry
place, well away from sources of
ignition, until you need it again.
Long-term storage
See "Storing the machine"
Adjustable flow oil pump is a special
option.
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
Use the adjusting screw (1) (on
underside of machine) to vary the oil
feed rate as required.
Ematic position (E), medium oil flow rate
–
N turn the adjusting screw to "E"
(Ematic position).
To increase oil feed –
N turn the adjusting screw clockwise.
Turn reduce oil feed –
N turn the adjusting screw
counterclockwise.
The chain must always be wetted with a
film of lubricant.
N Flip the bar – after each sharpening
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
N Periodically clean the oil inlet
hole (1), oil outlet channel (2) and
bar groove (3)
N Measure groove depth – using the
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
Oil Quantity Control
001BA157 KN
1
Taking Care of the Guide Bar
2
3
1
143BA026 KN