Instruction manual

MS 362, MS 362 C
English
32
If the groove is not at least this deep:
N Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
The air filter system can be adapted to
suit different operating conditions by
installing a choice of filters. Changing
the filter is quick and simple.
The saw comes standard with either a
fleece filter or a fabric filter.
Fleece filter with felt prefilter
For normal, dry and very dusty work
areas.
Fabric filter
For severe winter conditions (e.g.
powder and drifting snow, frost).
If there is a noticeable loss of engine
power
Removing the shroud
N Move the Master Control lever to the
stop position (0).
N Push the hand guard forward – the
chain is locked.
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
Removing the air filter
N Clean away loose dirt from around
the filter.
To avoid damaging the filter, do not use
tools for removing and installing the air
filter.
Chain type Chain pitch Minimum
groove depth
Picco 1/4“ P 4.0 mm
Rapid 1/4“ 4.0 mm
Picco 3/8“ P 5.0 mm
Rapid 3/8“; 0.325“ 6.0 mm
Rapid 0.404“ 7.0 mm
Air Filter System Cleaning the Air Filter
1
1
1
001BA199 KN
2