Operating instructions

58 YP2425F/YP4025F Table of Contents Index Great Plains Manufacturing, Inc.
403-362M Table of Contents Index 2013-03-25
Speed Set Calibration Setup
48. At the Main Work screen, press the Speed Set
button .
49. Enter desired values using Table as reference.
50. Press the Work Screen button when ground
speed calibration configurations are complete to
return to the Main Work screen.
Speed Set
Default
Value
or
Value to
Enter
Instructions/Definitions
Source
Digital
Frequenc
y
Select CAN Ground if radar is
connected to ISO tractor cab
harness. Select Digital Frequency if
radar or hall-effect is connected to
WSMT actuator harness.
Gspd
Consta
nt
10000
(@100
m)
12192
(@400 ft)
Input based on pulse count
produced by the ground speed
sensor over 100m or 400ft course.
See PDC Operator manual for
calibration instructions.
Shutoff
Speed
0.8 kph
0.5 mph
Set desired minimum ground speed
allowed before the system shuts off.
Minimu
m
Overrid
e
3.2 kph
2.0 mph
Set to operate when actual ground
speed falls below the designated
value. Control will operate at this
speed until actual ground speed
rises above minimum override
speed or actual speed drops below
shutoff.
Master
Sw
Timeo
ut
10
Set to desired number of seconds
system shuts off if the master
switch is turned on and there is no
ground speed. Toggle master
switch to restart the system and
turn off alarm.
Gspd
Fail
Alarm
Delay
5
Set to desired number of seconds
alarm sounds after the ground
speed is zero and seed flow
continues. (Monitor only).
Precha
rge
Groun
d0
Set to the desired speed the system
will use when a precharge time has
been enabled for a control channel.
Refer to Table : Planter Control