Operating instructions

- 20 -
EBA 480 EP
480EP
cm
inch
cm
inch
•
Operation
•
Start machine
•
Main switch
F
to position "I", insert the key
H
for the control panel and turn it to the right.
Open the front safety guard
A
• Press
S
button
O
 backgauge
I
moves
to the rear and searches for the reference
position, wait until 45 cm or 17,72 inches
is shown in the display
D.
Warning!
Before storing or cutting a measurement
please check if the correct measurement
scale (cm or inch) see above is stored.
For information on how to store see picture
below left.
Cutting to specified dimensions
•
Enter dimension on the numerical key pad
Q
 LED "S"
X
appears.
(If a wrong dimension is entered this can be
corrected by pressing the
s
button).
•
Press
S
button  dimension is
approached,  LED "S" disappears.
Dimensions below 9 cm can only be
approached with the
S
button pressed and
held. (When the
S
button
O
is released,
the backgauge
I
moves to a measurement
of 9 cm  measurement 9 cm blinks, keep
the
S
button pressed, backgauge
I
moves
to e.g. 7 cm.
•
Insert paper and move by means of the
stacking angle to the backgauge
I
and side
lay on the left
J
.
Turn the hand-wheel
E
for paper clamping to
the right and tighten with a short twist.
•
Close the front safety guard
A.
•
Release the cut.
Cut according to markings
•
Adjust the backgauge with the hand-wheel or
crank handle
G
to the back.
•
Insert paper and move by means of the
stacking angle to the backgauge
I
and side
lay on the left
J.
•
Turn the hand-wheel or crank handle
G
to
the right until the marking on the paper to be
cut is below the cutting line indicator.
•
The further the hand-wheel
G
is turned to the right, the quicker the
backgauge moves. If the hand-wheel is turned
to the left the backgauge will return quicker.