Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 13 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
CONSTRUCTION DOCUMENTATION
The contractor shall supply, at the time of delivery, at least one (1) copy of the following documents:
The manufacturers record of apparatus construction details, including the following information:
1) Owner’s name and address
2) Apparatus manufacturer, model, and serial number
3) Chassis make, model, and serial number
a) GAWR of front and rear axles and GVWR
b) Front tire size and total rated capacity in pounds (kilograms)
c) Rear tire size and total rated capacity in pounds (kilograms)
d) Chassis weight distribution in pounds (kilograms) with water and manufacturer-mounted equipment (front and
rear)
e) Engine make, model, serial number, rated horsepower and related speed, and governed speed; and if so
equipped, engine transmission PTO(s) make, model, and gear ratio
f) Type of fuel and fuel tank capacity
g) Electrical system voltage and alternator output in amps
h) Battery make, model, and capacity in cold cranking amps (CCA)
i) Chassis transmission make, model, and serial number; and if so equipped, chassis transmission PTO(s) make,
model, and gear ratio
4) Pump make, model, rated capacity in gallons per minute (liters per minute where applicable), and serial number
5) Pump transmission make, model, serial number, and gear ratio
6) Auxiliary pump make, model, rated capacity in gallons per minute (liters per minute where applicable), and serial
number
7) Water and Foam tank certified capacity in gallons or liters
8) Paint manufacturer and paint number(s)
9) Company name and signature of responsible company representative
10) If the apparatus is a mobile foam fire apparatus, the certification of foam tank capacity
11) Certification of compliance of the optical warning system
12) Siren manufacturer’s certification of the siren
13) Written load analysis and results of the electrical system performance tests
14) Certification of slip resistance of all stepping, standing, and walking surfaces
15) If the apparatus has a fire pump, the pump manufacturer’s certification of suction capability
16) If the apparatus is equipped with a fire pump and special conditions are specified by the purchaser, the pump
manufacturer’s certification of suction capacity under the special conditions
17) If the apparatus has a fire pump, a copy of the apparatus manufacturer’s approval for stationary pumping applications
18) If the apparatus has a fire pump, the engine manufacturer’s certified brake horsepower curve for the engine furnished,
showing the maximum governed speed
19) If the apparatus has a fire pump, the pump manufacturer’s certification of the hydrostatic test
20) If the apparatus has a fire pump, the certification of inspection and test for the fire pump
21) If the apparatus is equipped with an auxiliary pump, the
apparatus manufacturer’s certification of the hydrostatic test
22) When the apparatus is equipped with a water tank, the certification of water tank capacity
23) If the apparatus has an aerial device, the certification of inspection and test for the aerial device
24) If the apparatus has an aerial device, all the technical information required for inspections to comply with NFPA 1911,
Standard for the Inspection, Maintenance, Testing, and Retirement of In-Service Automotive Fire Apparatus
25) If the apparatus has a foam proportioning system, the foam proportioning system manufacturer’s certification of
accuracy and the final installer’s certification the foam proportioning system meets this standard
26) If the system has a CAFS, the documentation of the manufacturer’s pre delivery tests
27) If the apparatus has a line voltage power source, the certification of the test for the power source
28) If the apparatus is equipped with an air system, air tank certificates, the SCBA fill station certification, and the results
of the testing of the air system installation
29) Any other required manufacturer test data or reports.