Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 43 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
FRAME WARRANTY
The frame and cross members shall carry a limited lifetime warranty to the original purchaser. The warranty shall include
conditional items listed in the detailed warranty document which shall be provided upon request.
FRAME CLEAR AREA
The chassis frame shall be left clear of chassis mounted components inside or outside the frame rails within the first 30.00
inches behind the cab to allow space for OEM installed components. Cross members may be installed in the clear area if
required for proper frame or driveline configuration.
FRAME PAINT
The frame shall be powder coated black prior to any attachment of components.
All powder coatings, primers and paint shall be compatible with all metals, pretreatments and primers used. The cross
hatch adhesion test per ASTM D3359 shall not have a fail of more than ten (10) squares. The pencil hardness test per
ASTM D3363 shall have a final post-curved pencil hardness of H-2H. The direct impact resistance test per ASTM D2794
shall have an impact resistance of 120.00 inches per pound at 2 mils. The salt spray resistance per ASTM B-117-97
shall pass 500 hours of salt spray test. The applied process shall allow the application of other products over it and still
maintain or exceed the 500 hours salt spray test.
Any proposals offering painted frame with variations from the above process shall not be accepted. The film thickness of
vendor supplied parts shall also be sufficient to meet the performance standards as stated above.
The chassis under carriage consisting of frame, axles, driveline running gear, air tanks and other chassis mounted
components shall be painted the primary/lower cab color. Paint shall be applied prior to airline and electrical wiring
installation.
FRONT BUMPER
The chassis shall be equipped with a severe duty front bumper constructed from structural steel channel. The bumper
material shall be .38 thick ASTM A36 steel which shall measure 12.00 inches high with a 3.05 inch flange and shall be
99.00 inches wide with angled front corners.
The bumper shall be primed and painted as specified.
FRONT BUMPER EXTENSION LENGTH
The front bumper shall be extended approximately 18.00 inches ahead of the cab.
FRONT BUMPER EXTENSION WIDTH
The front bumper extension shall include an overall width of 34.25 inches.
FRONT BUMPER PAINT
The front bumper shall be painted the same as the lower cab color.