Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 45 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
CAB TILT SYSTEM
The entire cab shall be capable of tilting 45.00 degrees to allow for easy maintenance of the engine and transmission.
The electric-over-hydraulic lift system shall include an ignition interlock and red cab lock down indicator lamp on the tilt
control which shall illuminate when holding the “Down” button to indicate safe road operation.
It shall be necessary to activate the master battery switch and set the parking brake in order to tilt the cab. As a third
precaution the ignition switch must be turned off to complete the cab tilt interlock safety circuit.
Two (2) spring-loaded hydraulic hold down hooks located outboard of the frame shall be installed to hold the cab securely
to the frame. Once the hold-down hooks are set in place, it shall take the application of pressure from the hydraulic cab
tilt lift pump to release the hooks.
Two (2) cab tilt cylinders shall be provided with velocity fuses in each cylinder port. The cab tilt pivots shall be 1.90 inch
ball and be anchored to frame brackets with 1.25 inch diameter studs.
A steel safety channel assembly shall be installed on the right side cab lift cylinder to prevent accidental cab lowering.
The safety channel assembly shall fall over the lift cylinder when the cab is in the fully tilted position. A cable release
system shall also be provided to retract the safety channel assembly from the lift cylinder to allow the lowering of the cab.
CAB TILT CONTROL RECEPTACLE
The cab tilt control cable shall include a receptacle which shall be temporarily located on the right hand chassis rail rear of
the cab to provide a place to plug in the cab tilt remote control pendant. The tilt pump shall include 8.00 feet of cable with
a 6-pin Deutsch connector that includes a cap. The remote control pendant shall also include 20.00 feet of cable which
includes a mating connector.
CAB WINDSHIELD
The cab windshield shall have a surface area of 2825.00 square inches and be of a two (2) piece wraparound design for
maximum visibility.
The distance from the driver and officer to the windshield shall be a minimum of 42.00 inches at the furthest seated
position. This distance shall ensure the safety of the driver and officer from intruding objects in the unlikely event of a
head on collision.
The glass utilized for the windshield a standard automotive tint. The left and right windshield shall be fully interchangeable
thereby minimizing stocking and maintenance costs. All proposals offering windshields not in compliance with the
minimum measurement of surface area stated above and are not fully interchangeable shall not be considered.
GLASS FRONT DOOR
The front cab doors shall include a window which is 27.00 inches in width X 26.00 inches in height. These windows shall
have the capability to roll down completely into the door housing. This shall be accomplished manually utilizing a crank
style handle on the inside of the door. A reinforced window regulator assembly shall be provided for severe duty use.
There shall be an irregular shaped fixed window which shall measure 2.50 inches wide at the top, 8.00 inches wide at the
bottom X 26.00 inches in height, more commonly known as “cozy glass” ahead of the front door roll down windows.
The windows shall be mounted within the frame of the front doors trimmed with a black anodized ring on the exterior.