Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 48 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
UNDER CAB INSULATION
The underside of the cab tunnel surrounding the engine shall be lined with multi-layer foam insulation, engineered for
application inside diesel engine compartments.
The insulation shall act as a noise barrier, absorbing noise thus keeping the decibel level in the cab well within NFPA
recommendations. As an additional benefit, the insulation shall assist in sustaining the desired temperature within the cab
interior.
The insulation shall measure .56 inch thick including a 1.0#/sf PVC barrier and a moisture and heat reflective foil backing,
reinforced with fiberglass strands. The foil surface acts as protection against moisture and other contaminants. The
insulation shall meet or exceed FMVSS 302 flammability test.
The insulation shall be cut precisely to fit each section and sealed for additional heat and sound deflection. The insulation
shall be held in place by 3 mils of acrylic pressure sensitive adhesive and aluminum pins with hard hat, hold in place
fastening heads.
INTERIOR TRIM FLOOR
The floor of the cab shall be covered with a multi-layer mat consisting of 0.25 inch thick sound absorbing closed cell foam
with a 0.06 inch thick non-slip vinyl surface with a pebble grain finish. The covering shall be held in place by a pressure
sensitive adhesive and aluminum trim molding. All exposed seams shall be sealed with silicone caulk matching the color
of the floor mat to reduce the chance of moisture and debris retention.
The floor shall have an overlay of 3003-H22 aluminum embossed tread plate which is 0.084 inches thick. The tread plate
shall be held down with screws and aluminum trim molding.
INTERIOR FLOOR MAT COLOR
The cab interior floor mat shall be gray in color.
INTERIOR TRIM VINYL
The cab interior shall include trim on the front and rear crew ceiling, the cab walls and the rear wall of the cab. The trim
shall be constructed of insulated vinyl over a hard board backing. The trim shall be securely fastened to the interior of the
cab utilizing snap style fasteners with a decorative cover for a more appealing appearance.
INTERIOR TRIM VINYL COLOR
The cab interior vinyl trim surfaces shall be gray in color.
REAR WALL INTERIOR
The rear wall of the cab shall be trimmed with vinyl.
INTERIOR ABS TRIM COLOR
The cab interior vacuum formed ABS composite trim surfaces shall be gray in color.