Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 50 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
AUXILIARY POWER POINT COMPARTMENTS
The cab interior shall include two (2) 12 volt cigarette lighter type receptacles wired directly to the batteries. These
receptacles shall be provided to act as a power source for additional portable or mobile items and shall be located one (1)
in the glove compartment within the dash, and one (1) under the officer side seat inside the seat box riser.
STEP TRIM
Each cab entry door shall include a three step entry. The first step closest to the ground shall be constructed of polished
5032 H32 aluminum Grip Strut® grating with angled outer corners. The grating shall allow water and other debris to flow
through rather than becoming trapped within the stepping surface. The lower step shall be mounted to a frame which is
integral with the construction of the cab for rigidity and strength. The middle step shall be integral with the cab
construction and shall be trimmed in .084 inch thick 3003-H22 embossed aluminum tread plate.
INTERIOR DOOR TRIM
The doors of the cab shall include an aluminum plate the same weight and grade as the cab on the interior of the door.
The aluminum shall be then painted.
DOOR TRIM KICKPLATE
The inner door panels shall include an aluminum tread kick plate which shall be fastened to the lower portion of the door
panels.
CAB PAINT INTERIOR DOOR TRIM
The inner door panel surfaces shall be painted with a Zolatone #20-72 silver gray texture finish.
DOOR TRIM CUSTOMER NAMEPLATE
The interior door trim on the front doors shall include a customer nameplate which states the vehicle was custom built for
their Department.
CAB DOOR TRIM REFLECTIVE
The interior of each door shall include high visibility reflective tape. A white reflective tape that measures 1.00 inch in
width shall be provided vertically along the outer rear edge of the door. The lowest portion of each door skin shall include
a reflective tape chevron with red and yellow stripes and a Spartan logo. The chevron tape shall measure 6.00 inches in
height.
INTERIOR GRAB HANDLE "A" PILLAR
There shall be two (2) rubber covered 11.00 inch grab handles installed inside the cab, one on each “A” post at the left
and right door openings. The left handle shall be located 8.75 inches above the bottom of the door window opening and
the right handle shall be located 1.00 inch above the bottom of the door window opening. The handles shall assist
personnel in entering and exiting the cab.