Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 69 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
OVERALL HEIGHT, LENGTH DATA PLATE (US)
The fire apparatus manufacturer shall permanently affix a high-visibility label in a location visible to the driver while
seated.
The label shall show the height of the completed fire apparatus in feet and inches, the length of the completed fire
apparatus in feet and inches, and the GVWR in pounds.
Wording on the label shall indicate that the information shown was current when the apparatus was manufactured and
that, if the overall height changes while the vehicle is in service, the fire department must revise that dimension on the
plate.
ACCIDENT PREVENTION
There shall be a placard in the cab seating area which reads, "ALL OCCUPANTS MUST BE SEATED AND BELTED
WHEN THE APPARATUS IS IN MOTION".
PERSONNEL CAPACITY
A label that states the number of personnel the vehicle is designed to carry shall be located in an area visible to the driver.
ACCIDENT PREVENTION
If the rear bumper is 8" deep or more, there shall be a placard on the rear face of the body, in clear sight from the ground,
which reads, "WARNING - DO NOT RIDE ON STEPS OR DECK AREAS WHILE THE APPARATUS IS IN MOTION.
DEATH OR SERIOUS INJURY MAY RESULT".
WEARING HELMET WARNING
A label stating “DO NOT WEAR HELMET WHILE SEATED” shall be visible from each seating location.
FRONT BUMPER
The front bumper shall be as provided by the cab/chassis manufacturer. No other alternation or modifications are
required.
BUMPER GRAVELSHIELD
The bumper extension gravel shield shall be provided by the cab/chassis manufacturer.
BUMPER COMPARTMENT HOSE WELL
The bumper extension shall have one (1) hose well compartment in the center of the bumper extension. The compartment
shall have a capacity of 200’ of 1-3/4 double jacketed structure hose with a 1-½ TFT nozzle with pistol grip. The well shall
be mounted between the frame extension rails.
The hose well shall be covered with a 1/8” tread plate lid attached with a stainless steel piano hinge. The cover shall have
a quick release latch. The hose connection shall be on the officer’s side of the bumper apron on a swivel mount.
The pre-connected piping shall have an auto-drain to prevent freezing.