Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 76 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
REFLECTIVE STRIPE - CAB SIDE
A retroreflective stripe(s) shall be affixed to at least 50 percent of the cab and body length on each side.
The stripe or combination of stripes shall be a minimum of 4 in. (100 mm) in total width.
The 4 in. (100 mm) wide stripe or combination of stripes shall be permitted to be interrupted by objects (i.e., receptacles,
cracks between slats in roll up doors) provided the full stripe is seen as conspicuous when approaching the apparatus.
 The stripe material shall be 3M Scotchcal 680.
 This reflective stripe shall be white in color.
There shall be a 1" Scotchcal reflective stripe located approx. 1" above the main stripe.
 This reflective stripe shall be blue in color.
REFLECTIVE STRIPE - CAB FRONT
A reflective stripe shall be affixed to the front of cab. The stripe or combination of stripes shall be a minimum of 4 in. (100
mm) in total width.
A retroreflective stripe(s) shall be affixed to at least 25 percent of the width of the front of the apparatus.
 The stripe material shall be 3M Scotchcal 680.
 This reflective stripe shall be white in color.
There shall be a 1" Scotchcal reflective stripe located approx. 1" above the main stripe.
 This reflective stripe shall be blue in color.
CHEVRON STRIPE - CAB BUMPER
A reflective stripe shall be affixed to the front of cab. The stripe or combination of stripes shall be a minimum of 4 in. (100
mm) in total width.
The approximate 10" wide Chevron retroreflective stripe shall be affixed to at least 25 percent of the width of the front of
the apparatus with retroreflective striping in a chevron pattern sloping downward and away from the centerline of the
vehicle at an angle of 45 degrees. Each stripe shall be 6" width. Chevron panels shall have a 3M UV over laminate to
protect from UV rays, scene damage, and everyday use. Chevron panels shall have a minimum 10 year warranty for
material failure, and colorfastness.
 The stripe material shall be 3M Scotchlite Diamond Grade.
All retroreflective materials required shall conform to the requirements of ASTM D 4956, Standard Specification for
Retroreflective Sheeting for Traffic Control, Section 6.1.1 for Type I Sheeting.
 This reflective chevron stripe shall alternate red and fluorescent yellow-green in color.