Specifications

Loveland Fire/Rescue
Pumper
Production Specification
SVI #769 Page 88 of 125 June 17, 2010
..\4) Pricing & Change Orders\Production Change Order.pdf
PLASTIC FLOOR AND SHELF TILE
All compartment floors, shelves, and trays shall be covered with Dri-Dek plastic interlocking grating.
 The plastic floor tile shall be black.
 The plastic edge trim shall be red.
LADDER LIFT SYSTEM, CURBSIDE
A Ziamatic 12 volt DC, 60 amp, HLAS (Horizontal Ladder Access System, Part no. 3097-500-000) shall be provided
above the exterior side body compartments, on the curbside.
The lift system shall be electro-hydraulic with built-in electric safety latches and warning alarm when in operation. Access
shall still be provided to compartments with system in lowered position. Flashing lights on ends shall produce a visual
signal when the system is out of the stored position.
The ladder control panel shall be located on curbside pump panel. The ladder lift system shall be designed to store the
specified ladder compliment specified.
Storage shall be provided for the following SVI supplied ladders and pike poles;
One (1) Duo-Safety 900-A aluminum 24' 2-section ladder (14' 2 3/4" x 21 3/4" x 5 3/8")
One (1) Duo-Safety 775-A aluminum 14' roof ladder (14' 2 1/2" x 19" x 2 3/4")
One (1) Duo-Safety 585-A aluminum 10' folding ladder (11' 3 1/2" x 1 3/4" x 3 3/4")
One (1) Duo-Safety 10 FP 10' pike pole
One (1) Nupla 8' Trash/Arson hook with fiberglass handle
LADDER LIFT INTERLOCK
An interlock circuit shall be included on the ladder lift system to prevent the lift from raising if the curbside hose bed door
is in the open position.
SIDE BODY PROTECTION - RUB RAIL
There shall be side rub rails provided below the compartment door openings on both the streetside and curbside. The rub
rail shall be fabricated from 6063 extruded aluminum, measuring approximately 2-3/4" high x 1-3/8" thick with tapered
aluminum end caps. The rub rail shall be bolted to the body using stainless steel bolts and 1-1/2" diameter x 5/8" thick
rubber mount isolators to prevent damage to the body. The rails shall incorporate LED clearance marker lighting
recessed into the rail fascia to avoid damage to the light in case of impact. The rub rail shall have an accessory mounting
track integrated into the backside of the rail to allow mounting of accessories such as ground lighting.
− 3M™ Diamond Grade™ Conspicuity striping shall be provided in the rub rail. The striping shall be red in
color.
REAR BODY HANDRAILS
There shall be two (2) vertical handrails on the rear of the body. Handrails shall be NFPA compliant 1-1/4" extruded
aluminum tubing with chrome plated end stanchions.