Specifications

18
Manual
ProtoMat 95s/II
If, for whatever reason, it should be necessary to switch the machine off and back on, you
must switch briefly to the BoardMaster Machine Settings... dialogue box and quit this with
OK. This will transmit all necessary initialization parameters, such as speed ranges, wait
times, positions and so on to the machine.
BoardMaster warning: Hood is open
No compressed air feed.
BoardMaster displays the above notice if the hood is not closed, or there is no compressed
air feed to the LPKF ProtoMat 95s/II. These faults must be rectified before work can
continue.
You must first run in the bearings on the high-frequency spindle when starting up the
machine if it has been shut down for a prolonged period or if the machine has just been
shipped.
Thereafter the control system automatically specifies that the spindle be warmed up (at
20,000 rpm) for about 3 to 5 minutes whenever the machine is switched on. The length of the
warm-up period is determined by the length of the shutdown period. It is not possible to set a
speed above 20,000 rpm during the warm-up period. The machine will automatically switch to
the higher set speed once the warm-up period is over. BoardMaster controls these
procedures automatically.
Information box for warm-up period