Specifications

ProtoMat 95s/II
Manual
19
3.3 Preparing the tools
3.3.1 The spacer ring press
All tools must be fitted with spacer rings to ensure the precise pick up and set down of tools.
1
2
3
4
5
The spacer ring press used to force the spacer rings onto the tools comprises the following
parts:
1.
Magazine for spacer rings
2.
6 bar compressed air connection
3.
Cover cap with pneumatic switch
4.
Pressing tool with drill inserted
5.
Spacer ring ready for pressing
The spacer rings are fed into the spacer ring press magazine
(1)
and the tool
(4)
is pushed
into the pressing tool with the cutting edge towards the spacer ring
(5)
. The cover cap
(3)
must now be closed to the stop so that pressing can take place. The prepared tool may now
be removed.
Caution:
The working depth of the tool concerned will be too deep if the tool has not
been pressed into the ring as far as the stop.