Specifications

30
Manual
ProtoMat 95s/II
15.
The H
OME
position must be corrected if the milled line does not pass exactly through
the centre point.
This can be done directly by amending the H
OME
position in the
M
ACHINE
S
ETTINGS
dialogue box (see the section entitled "Programming the H
OME
position in LPKF
BoardMaster").
The correct value can be calculated using the formula given above.
The Y coordinates must always be added
to the correction value.
16.
After making a correction, the process should be repeated as a check. It is advisable
that you use the second hole and milling track in the test program if the same board is
to be used to perform the check.
17. Note the coordinates of the new H
OME
position.