Specifications

ProtoMat 95s/II
Manual
41
5 Tools, material and accessories
5.1 Tools
Tools for the LPKF ProtoMat 95s/II have a diameter of 1/8 inch and two different lengths.
Tools used to machine the material surface (milling and engraving) are 36 mm long while
tools used for drilling or contour milling are 38 mm long.
The following tools are available.
31
56
2
4
LPKF tools for circuit board plotter
1.
36 mm long LPKF Universal LPKF cutter for milling isolation channels and for
engraving front plates from 0.2 - 0.5 mm (depending on depth set).
2.
36 mm long LPKF micro Cutter for milling 0.1 to 0.2 mm isolation channels (depending
on depth set) with a 17µm copper cladding on the board material.
3.
LPKF RF milling cutter for creating 0.25 mm or 0.4 mm wide
rectangular section isolation channels.
4.
36 mm long double-edged cutter (end-mill; 0.8 mm; 1 mm; 2 mm) for engraving front
plates and for engraving wider isolation channels.
5.
38 mm long twist drill of various diameters for drilling in board material.
6.
38 mm long contour cutter (1.0 mm; 2.0 mm) for milling out cut-outs in the board
material.