Specifications

56
Manual
ProtoMat 95s/II
16.
Once the holes of the current diameter have been drilled, the next tool is fitted in the
same way.
17.
When the drilling phase has finished, the
M
ILLING
B
OTTOM
milling phase is selected
once any galvanic through-hole plating has been carried out.
18.
The milling depth should now be set. To do this, click on Universal Cutter 0.2 mm in
the Tools combo box (top left in the screen).
19.
The plotter head travels to the zero position. The auxiliary clamp fetches the universal
milling cutter from the tool magazine and takes it to the transfer station where it is
handed over automatically.
20.
Use the traverse buttons in BoardMaster to move to a vacant point on the board
material but without moving across the project.
21.
Set the step size to 5-10 mm in the
S
TEP SIZE
box.
Use the
A
UTO
M
OTOR
O
N
/O
FF
button to switch off the motor and the
M
OTOR
O
N
/O
FF
button to switch the motor back on,
lower the head by clicking on
and move with the traverse buttons.
Set the milling depth. See also the section entitled "How the mechanical working depth
limiter works".
22.
The milling data can now be selected by clicking on
. The selected data is
shown lighter.
23.
Use the
M
OTOR
O
N
/O
FF
button to switch the motor off and the
A
UTO
M
OTOR
O
N
/O
FF
button to switch the motor back on.
Use the
button to start the machining.
24.
Then move to the P
AUSE
position and turn the material if you are machining a double-
sided board.
25.
Select the
M
ILLING
T
OP
milling phase and machine as described above.
26.
If required, select the
C
UTTING
mill phase and machine with a contour cutter.
27.
Move to the P
AUSE
position, remove the board and proceed as described in the section
entitled "Cleaning the board".
Caution
The hood must always be closed whenever the there is any movement
during a tool change.
The tool magazine is moved by compressed air. This increases the risk of
fingers being crushed.