Specifications

ProtoMat 95s/II
Manual
61
7.4 Connecting the stepping motors
The stepping motors are connected per axis via a 15-pole SUB-D plug.
If a limit switch is actuated, any further axis movement towards
the limit switch is immediately
blocked.
The position of the sockets is described in the
"LPKF ProtoMat 95s/II displays and connections" section.
Caution
Never confuse the cable for the stepping motor and the plotter head.
7.5 Connecting the plotter head
The plotter head is connected to the control unit by a 15-pole socket.
The position of the sockets is described in the "LPKF ProtoMat 95s/II displays and
connections" section.
A further 5-pin cable supplies the high-frequency spindle.
Caution
Never confuse the cable for the stepping motor and the plotter head.
7.6 Setting the tool change positions
The machine must be in operational mode for this adjustment to be made.
The metal hood on the front of the machine must be removed before the adjustments can be
made.
1.
Do this by undoing the 6 (2x3) bolts on either side of the hood (see illustration below).