Specifications

ProtoMat 95s/II
Manual
67
The plotter head collet closes and grips the tool.
10.
Shift the entire Tool magazine window down the screen until you can see the BoardMaster
main menu bar.
11.
Enter the value 0.1mm in the step window. Make sure that you enter a decimal
point
between the zero and the one.
12.
Lift the tool change magazine carefully with both hands (as shown on the right in the
illustration below) observe whether the appropriate changeover station or collet can be
properly moved over the tool. If it stutters or jams, check carefully in which direction the
position of the plotter head has to be corrected.
Auxiliary gripper Changeover-station Plotter head Tool change magazine
13.
If necessary, correct the plotter head position using the arrow keys in the main menu bar.
14.
Then repeat steps 12 to 13 until the transfer station can be shifted over the tool with no
problem.
15.
Click on R
EAD
in the P
OSITION OF PLOTTER HEAD OVER TRANSFER STATION
(
MM
) tool
magazine window.
The coordinates set for the plotter head are now imported and saved.
16.
Now click on O
PEN
in the C
OLLET
window.
17.
Remove any tool from the collet.
18.
Click on C
HECK
in the Position of auxiliary gripper over transfer station (mm)
window.
The auxiliary gripper moves to the corresponding check position.
19.
Insert the tool into the auxiliary gripper
as far as the stop
.