Specifications

68
Manual
ProtoMat 95s/II
20.
Now click on C
LOSE
in the C
OLLET
window.
The collet clamps the tool in the auxiliary gripper.
21.
Now repeat position adjustment as described in steps 12 to 14 again until the tool in the
auxiliary gripper can be moved to the transfer station without problem.
22.
Click on R
EAD
in the P
OSITION OF AUXILIARY GRIPPER OVER TRANSFER STATION
(
MM
) window.
The coordinates set are read by the system and saved.
23.
Click on O
PEN
in the C
OLLET
window.
24.
Remove the tool and insert it in position 1 of the tool change magazine (on the right).
25.
Click on C
HECK
in the P
OSITION OF AUXILIARY GRIPPER OVER FIRST TOOL
window.
The auxiliary gripper moves to the corresponding check position.
26.
Check the position as described in steps 12 to 14 and correct it if necessary.
27.
Click on R
EAD
in the P
OSITION OF AUXILIARY GRIPPER OVER FIRST TOOL
window.
The coordinates set are read by the system and saved.
28.
Now insert the tool in position 30 of the tool change magazine (on the left).
29.
Click on C
HECK
in the P
OSITION OF AUXILIARY GRIPPER OVER LAST TOOL
window.
The auxiliary gripper moves to the corresponding check position.
30.
Check the position as described in steps 12 to 14 again for this position.
31.
Correct the position if necessary.
32.
Click on R
EAD
in the P
OSITION OF AUXILIARY GRIPPER OVER LAST TOOL
window.
The coordinates set are read by the system and saved.
33.
Now remove any tools in the machine.
34.
Now click on C
LOSE
in the C
OLLET
window.
35.
Click on OK.
Tool change position adjustment is now complete.
Now reconnect the pneumatic hose disconnected at the start and refit the cover.
7.7 EPROMs
The software for the control unit is in 2 EPROMs.
The LPKF ProtoMat 95s/II will have to be partially dismantled if the EPROMs need to be
changed (updates).
Proceed as described under "Removing the electronics unit".
Use only PLCC pliers to remove the EPROMs as otherwise the mounting contacts might be
damaged.
When inserting new EPROMs, support the PCB from the bottom in order to avoid bending of
the board.