Specifications

70
Manual
ProtoMat 95s/II
7.8
ProtoMat 95s/II
and AutoContac
As with all LPKF circuit board plotters, the ProtoMat 95s/II may be retrofitted with the LPKF
AutoContac through-hole plating system. A bracket for this must be attached to the plotter
head to hold the cartridge containing the conductive paste.
1
3
2
6
5
4
Attaching the AutoContac bracket
1.
Limit switches
2.
Plotter head mounting plate
3.
AutoContac bracket
4.
Knurled locating screw
5.
Elongated hole for guide pin
6.
Guide pin
The compressed air hoses (included with the parts supplied with the LPKF AutoContac) are
connected up to the ports on the DispoMat (see the LPKF P
ROTO
M
AT
95
S
/II
DISPLAYS AND
CONNECTIONS
section) and to the cartridge (see the F
UNCTIONAL ELEMENTS ON THE PLOTTER
HEAD
section).
BoardMaster switches from automatic tool change to manual change if the “Dispense” or
“Vacuum” production phase is selected since it is not possible to change the various
dispense and vacuum needles automatically. In addition the operator must attach the bracket
to the plotter head.
Caution :
Revert to the automatic tool change mode for drilling, engraving or milling.
The bracket must be removed as otherwise the plotter would be damaged by
the automatic tool change.