Specifications

Setup
ProtoMat 95s/II 25
5.0 Setup
5.1 Before switching on
Caution! You must ensure that the voltage set on the machine
corresponds with the mains line voltage before switching on. If not,
see the section headed
Setting the device voltage, electrical fuses.
Remove all objects from the plotter and its traverse range before
switching on. Pilot pins must not be projecting from the base material.
Caution! Carefully close the hood.
Never reach into the machine while it is running.
Never move the plotter head manually. Doing so could damage the
electronics.
5.2 Switch-on sequence
It is absolutely vital that you follow the switch-on sequence to guarantee
trouble-free use of the
ProtoMat
95s/II.
The circuit board plotter must be switched on and the initialization run
completed before
BoardMaster
is started. Otherwise it will not be
possible to execute the communication operations that occur as soon as
BoardMaster
is started.
1.
Computer
2.
LPKF
ProtoMat
95s/II
3.
Start the
BoardMaster
program