Specifications

Setup
26 ProtoMat 95s/II
The following screen will appear when the program is started:
fig. 11: The Tool Status dialogue
box
Note: You must determine where any tool is located when the
machine is switched on. Next the vacant tool position in the tool
magazine must be specified:
Position 1 = tool 1 is positioned extreme right,
Position 30 = tool 30 is therefore positioned extreme left in the
tool magazine.
If, for whatever reason, it should be necessary to switch the machine off
and back on, you must switch briefly to the
BoardMaster MACHINE
SETTINGS...
dialogue box and quit this with
OK
. This will transmit all
necessary initialization parameters, such as speed ranges, wait times,
positions and so on to the machine.
fig. 12: BoardMaster warning: Hood
is open
fig. 13: No compressed air feed.
BoardMaster
displays the above notice if the hood is not closed, or there
is no compressed air feed to the LPKF
ProtoMat
95s/II. These faults
must be rectified before work can continue.