Specifications

Setup
ProtoMat 95s/II 41
fig. 29: Front strip of the registration
hole system
A new registration hole system is created as follows:
› First press the two registration hole strips into the machine groove,
with the front registration hole strip pushed against the reference pin
at the front of the groove.
The distance between the two registration hole strips should be
approximately the size of the base material in the x-axis.
› A special drill for drilling the registration hole system is provided in
the set of accessories. This drill is also contained in the
BoardMaster
tool library. This drill has the spacer ring pressed onto the tool such
that the distance to the plotter table is approximately 0.5 mm.
Caution! This tool is intended for drilling the registration hole
system only. Using this tool to drill boards may cause the tool to be
broken or the plotter to be damaged.
› Select the tool in
BoardMaster
: "Spiral Drill Ref 2.95 mm"
› To increase the drill stroke, adjust the work depth limiter to the top
using the knurled screw, in order to increase the drill stroke.
› Use
GO TO, HOME
from the
BoardMaster
menu to move the plotter
head to the HOME position and then use the traverse buttons to
move the head to approximately the centre of the front registration
hole strip.
1
- Axis of symmetry
5
- Registration hole stripe
2
- Reference pin, the stop for the front registration hole strip (5)
6
- Registration hole groove
3
- Front alignment pin
7
- Tool magazine
4
- HOME position, at least 10 mm from the front alignment pin
8
- Transfer station
1
2
34 5 6
8
7
Position 30
Position 1