Use and Care Manual

6
gROUNDINg INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk
of electric shock by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result in a risk of electric shock.
ELECTRICAL REQUIREMENTS
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is rec-
ommended that a separate circuit serving only this appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded. Should you only have a 2-prong
outlet,haveaqualiedelectricianinstallacorrectwallreceptacle.
A 3-prong adapter may be purchased and used temporarily if local codes allow.
Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled in or
tripping over a longer cord.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that
has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on
the microwave oven. The marked rating of the extension cord should be AC 115-
120 volt, 15 amp. or more.
Be careful not to drape the cord over the countertop or table where it can be pulled
on by children or tripped over accidentally.
Notes: 1. If you have any questions about the grounding or electrical instructions,
consultaqualiedelectricianorserviceperson.
2. Neither Sharp nor the dealer can accept any liability for damage to the
oven or personal injury resulting from failure to observe the correct
electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave
oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check
position and signal of receiving antenna.
UNPACKING AND EXAMINING YOUR OVEN
1. Remove all packing materials from inside the oven cavity; however, DO
NOT REMOVE THE WAVEGUIDE COVER, which is located on the
ceiling in the oven cavity. Read enclosures and SAVE the Operation
Manual.
2. Remove the feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door, dam-
aged door seals and sealing surfaces, broken or loose door hinges and
latches and dents inside the cavity or on the door. If there is any damage,
do not operate the oven and contact your dealer or SHARP AUTHORIZED
SERVICER.
CHOOSING A LOCATION FOR YOUR OVEN
You will use your oven frequently so plan its location for ease of use. The oven must be placed on a countertop
whichisaminimumof36inchesfromtheoor.Allowatleast2inchesonthesides,topandattherearofthe
oven for air circulation. Be sure to position oven so that the rear cannot be touched inadvertently.
INSTALLATION INSTRUCTIONS
Waveguide cover