8M-B32C1 Dismantle Instruction LCD MONITOR MODEL 8M-B32C1 Dismantle Instruction 1
8M-B32C1 Dismantle Instruction Table of contents 1. Scope.................................................................................................................. 3 2. Tools for dismantling ............................................................................................... 3 3. Dismantle Procedure .............................................................................................. 3 4. Stand, Back cover and PWB Plate ...........................................................
8M-B32C1 Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Stand, Back cover and PWB Plate (section 4) 2. Remove Printed circuit boards (section 5) 3. Remove Battery (section 6) 4. Dismantle LCD (section 7) 5.
8M-B32C1 Dismantle Instruction 4. Stand, Back cover and PWB Plate Stand can be removed with screw driver. Remove SCREW COVER SEAL on back cover. Then back cover can be removed with screw driver.
8M-B32C1 Dismantle Instruction Cut the cable tie on VESA angle with nipper, and peel off ALPET SHEET and ALPET SHEET S. Then remove VESA angle with screw driver.
8M-B32C1 Dismantle Instruction Detach the cables from DC switch PWB and remove the PWB with screw driver. Remove WIRING SHEET (Black PC sheet) from PWB Plate. Release all the cables that runs through the plate aperture. (cables from beneath the plate).
8M-B32C1 Dismantle Instruction Detach Key-FFC from the connector on Main I/F PWB Release from wire holders and remove the fixing tape on PWB Plate. Then PWB Plate can be removed with screw driver.
M-B32C1 Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver.
8M-B32C1 Dismantle Instruction 6. Battery This model uses only CR2032 Lithium Coin battery on Main I/F PWB. Battery CR2032 can easily be removed from the battery holder.
8M-B32C1 Dismantle Instruction 7.
8M-B32C1 Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB. These capacitors can be removed by using nipper to cut the leads.
8M-B32C1 Dismantle Instruction 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.