CAUTIONS 1, Please read this manual carefully before using the unit and retain it 5, Be sure to supply AC turret 1o power to this unit. Operation on & for future reference. different voltage revel may seriously damage this unit or cause a fire. 2. Exposing the unit o moisture can cause fire or electric shock. SHARP cen not be half responsible for any damage incurred during 3. This unit should not be exposed fo temperatures over 36°C {95°F) aeration with unspecified voltage levels. o below §°C {419F).
el ~ ASSEMBLING — 5. Align the turntable platter with the motor pulley using dither hole therein. writable peatier as 2 wide. Set the rubber belt around --the motor pulley. Do rot get grease on the blat, |f the bat doss become greasy, clean it with o cloth soaked in mentholated spirit {alcohol. Do not use benzine or thinners for cleaning. The bat should not he twisted, . Claps the mat on the tum table platter and gently press it into place, .
OPERATION SWITCHING SPEED SELECTOR The SPEED selector of this unit can be changed only when the turntable pastier is rotating, Even i the SPEED selector is switched when the turntable platter is not moving, the speed will not change, Observe the following procedure when changing turntable speed. 1. Turnover the tonearm clamp. : 2. Move the packinghouse control Jain ravel backwards. 3. Hood the head shell grip and swing the tonearm over the turntable 4.
el MANUAL PLAY 1. Follow step 1 10 type 4 and step 6 in the instructions for “AUTOMATIC PLAY” 85 given on page 4. 2, Move the menopause control ravel backwards. 3. Hold the headship grip and swing the tonearm 1o the playing position and the turntable platter will start 1o rotate, 4. Mace the cuing/pause control lever forward to lower the tonearm onto the record, §. Follow step 9 ta step 12 a3 given in the instructions for "AUTOMATIC PLAY” on page 4.
précautions 1. Veloutez lire malheureusement ce mode d’emploi avant &'utiliser appareil et e conserver pour références futures, Sous-exposition de Appareil & Humidité peut être la cause d'un incendie ou d'une électrocution, 3, Cet appareil ne soir pas éue exposé A des températures de plus de 35°C (95°F) ou de mains de 6°C De mémé, fuiter de placer cet appareil dans un endroit poussiéreux ou numide 4.
FRANGÉS — MONTAGE — 5. Aligner le plateau avec Is poule du moteur en se servant de 'un des trous du plateau, comme guide, Placer la courroie zn couteau autour delà poule du moteur. Ne pas graisser la courée. S Iy courrais devient Grasse, la nettoyer & Caire d'un tissu trempé d’alcool dénaturé, Ne pas utiliser de benzine ou de diluants pour la nettoyer, la SoUITois ne doit pas &tre torsadés, 8. Placer le tapis sur le plateau et I presser doucement en place. 7.
FONCTIONNEMENT COMMUTATION DU RELECTEUR DE VITESSE Le sélecteur de casse-vitesse uet appareil ne peut e change seulement que grand Ie plates tourne. Mme si e sélecteur SPEED est comaté quand e plateau ne tourne pos, ia vitesse ne changer pas. Observa Iz procédas suivant fars du changement de la vitesse de rotation. 1, Enlever Agrafe du bras de pick-up. 2. Déplacer le leviez décommande de mise en pile/pause vers 'arriéré. 3.