Operating instructions

2-50
INSTALLATION ORBAN MODEL 9400
B) Hold down the PC
CONNECT soft button and turn the knob until you see
D
IRECT on the display.
You are now ready to connect your computer to your 9400 through a null
modem cable connected to your computer’s serial port. Refer to Installing
9400 PC Remote Control Software on page 2-51.
Recalling Presets via Ethernet
using Terminal Emulator Software
You can connect a terminal emulation application to the 9400’s Ethernet port via
TCP/IP, port 23 (which is the standard Telnet port and the 9400 factory default).
When connected like this, you can recall presets.
The version of HyperTerminal that ships with Windows does not support TCP/IP con-
nections, although the full (paid, upgraded) version does. However, you can use the
freeware terminal emulation application PuTTY instead. The following description is
based on PuTTY Release 0.55:
http://www.chiark.greenend.org.uk/~sgtatham/putty/
A) Start PuTTY.
The S
ESSION window appears.
B) Click the T
ELNET button, which is hard-wired for Port 23.
C) In the T
ERMINAL category, check “Implicit CR in every LF.”
You should not have to change any other PuTTY Terminal, Window, or
Connection defaults
D) Type the 9400’s IP address into the “Host Name (or IP address)” field.
The IP address for this connection is the same as the IP address set in step
(1.B) on page 2-48 and is visible in the S
ETUP > NETWORK & REMOTE > SET
IP ADDRESS screen.
E) Name and save the Session if you wish.
F) Click O
PEN.
G) Activate the C
APS LOCK on your computer to ensure that you type in upper-
case.
To set a different port number:
A) Navigate to S
ETUP > NETWORK & REMOTE > TERMINAL PORT. If TERMINAL PORT is
not visible, press the N
EXT button as necessary to scroll it into view.
B) Press the T
ERMINAL PORT soft button.
C) Use the N
EXT and PREV keys to move the cursor in turn to each digit in the IP
port. Use the knob to set the digit to the desired value. Repeat until you have