Operating instructions

2-4
INSTALLATION ORBAN MODEL 9400
PIN ASSIGNMENT
1. DIGITAL GOUND
2. REMOTE 1+
3. REMOTE 2+
4. REMOTE 3+
5. REMOTE 4+
6. REMOTE 5+
7. REMOTE 6+
8. REMOTE 7+
9. REMOTE 8+
10. TALLY 1
11. TALLY 2
12. N/C
13. ANALOG GROUND
14. REMOTE 1-
15. REMOTE 2-
16. REMOTE 3-
17. REMOTE 4-
18. REMOTE 5-
19. REMOTE 6-
20. REMOTE 7-
21. REMOTE 8-
22-24. N/C
25. +12 VOLTS DC
REMOTE INTERFACE
Figure 2-2: Wiring the 25-pin Remote Interface Connector
7. Connec
t to a computer
You can connect to a computer via the 9400’s serial connector or via an Ethernet
network.
You must have the 9400 PC Remote application installed on your com-
puter before you upgrade your 9400’s firmware because 9400 PC Remote
manages the upgrade.
See Networking and Remote Control on page 2-47, Appendix: Setting Up Serial
Communications on page 2-59, Installing 9400 PC Remote Control Software on
page 2-51, and Using the 9400 PC Remote Control Software on page 3-61 for
more detail.
Figure 2-3: 9400 Serial Port Pin Identification