Operating instructions

2-36
INSTALLATION ORBAN MODEL 9400
of the L+R HF FR control until the ringing is again at the flattop modula-
tion level will unbalance the ringing at the leading and trailing edge of
the square wave, and necessitate further adjustment of the L+R HF 
control. Alternate between these two interactive controls until the peaks
of ringing at both the leading and trailing edges of the square wave are
at the flattop modulation level. Figure 2-11 illustrates a typical waveform
before adjustment and Figure 2-12 shows the result of a successful ad-
justment.
(The waveform produced by your system may look quite differ-
ent.)
H) Turn off the square wave generator and turn off the carrier to allow the
transmitter to cool down for several minutes:
a) Navigate to S
ETUP > TEST.
b) Set the M
ODE to OPERATE.
14. Set the L–R Transmitter Equalizer controls.
[Skip this step unless you are setting a CQUAM AM stereo facility. The controls
under adjustment in this step do not affect a mono facility if the 9400’s analog
processing chain is set to a mono mode.]
After you have set up the CQUAM exciter for best separation without any audio
processing by following its manufacturer’s instructions, you should trim the
9400’s L–R
HF FR and L–R HF  controls to maximize stereo separation through
the entire transmission chain, including the 9400. In most cases, you will maxi-
mize separation if you set these controls to the same settings as their L+R coun-
terparts. However, it may be worthwhile to sweep the system and trim the L–R
controls to maximize separation. To do so:
A) Navigate to S
ETUP > I/O CALIB.
B) Set the AM
PROC control to STEREO.
C) Navigate to S
ETUP > TEST.
D) Set the M
ODE to BYPASS.
E) Connect the output of a sweep generator to one input channel of the 9400
(either left or right). Ground the other channel to minimize crosstalk.
Alternatively, you can use a sweep generator with a digital output and
use the 9400’s digital input.
F) Set the sweep generator’s output level to produce about 50% modulation.
G) Observe the output of your CQUAM stereo modulation monitor correspond-
ing to the undriven channel.
H) Navigate to S
ETUP > MODIFY TX PRESET > TX1/DAY.
I) Press N
EXT until you see the L–R HF FR and L–R HF DELAY controls.
J) Set these controls the same as their L+R counterparts.