Operating instructions

2-40
INSTALLATION ORBAN MODEL 9400
b) Enter seconds slightly ahead of the correct time.
c) Wait until the entered time agrees with the correct time. Then press the
E
NTER TIME button to set the clock.
B) Press the S
ET DATE button.
a) Set today’s date, using the days, month, and year buttons.
b) Press the E
NTER DATE button.
C) Press the D
AYLIGHT TIME button.
a) Using the Daylight Saving (DT
MONTH and DT WEEK) buttons, set the month
and week when Daylight Saving Time (Summer Time) begins, or O
FF.
b) Using the Standard Time (ST
MONTH and ST WEEK) buttons, set the month
and week when Daylight Saving Time (Summer Time) ends.
Note that setting DT MONTH, DT WEEK, ST MONTH, or ST WEEK to OFF will
defeat Daylight Time functionality.
c) Press the Escape key to back out of the daylight saving screen.
D) (Optional) Press the S
TATION ID button to specify your station’s identifier (call
sign or call letters).
a) Use the knob to select characters. Use the P
REV and NEXT buttons to move
the cursor.
b) When you are finished, press
SAVE.
2. Navigate to Setup > Next > Automation.
If the A
UTOMATION button reads DISABLED, hold it down and turn the knob to en-
able automation.
This button allows you to easily enable or disable all automation events without
having to edit individual automation events.
3. To add an automation event:
A) Push the A
DD EVENT button.
B) Choose whether you wish to program an event that occurs only once or an
event that follows a daily or weekly schedule.
C) For events that occur only once:
a) Use the
PREV and NEXT buttons to move the cursor over the word “DAILY:”
and turn the knob so that is reads “
DATE:” instead.
b) Use the P
REV and NEXT buttons to move the cursor to the day, month, and
year when the automation event will occur. Set the desired values with the
knob.