Operating instructions

OPTIMOD-AM DIGITAL INSTALLATION
2-45
Autolock can only be turned on if at least one passcode exists with ALL
ACCESS privileges because an ALL ACCESS passcode is required to fully
unlock the panel or to turn off the Autolock function.
C) Press the ESCAPE button to leave the Security menu.
To Unlock the Front Panel:
A) On the 9400 front panel, operate any button or the knob.
The P
ASSCODE screen will appear.
B) Enter a passcode using the four soft buttons.
The 9400 functionality that you can access depends on the security level
of the passcode that you entered.
After you have finished working, the panel will automatically re-lock af-
ter the time delay you set in S
ETUP > SECURITY > AUTOLOCK. (You can set a
new delay at any time if you have an A
LL ACCESS passcode.)
Dial-up Networking and the Passcode
When you make a Windows Dial-up Networking connection, Windows will ask you
for your passcode. To allow the connection to occur, enter any passcode that you set
at the 9400’s front panel. Once your PC is connected to the 9400, you will be able to
access the 9400 functionality corresponding to the security level of your passcode.
If you have not set a passcode, leave the Windows dialog box blank.
If You Have Forgotten Your Passcode
You can reset factory defaults and wipe out security passcodes (in case you forgot
your A
LL ACCESS passcode).
A) Remove power from the 9400.
B) While pressing both the E
SCAPE and SETUP buttons, restore power.
The Restore Defaults screen appears.
C) To gain access to the 9400, press the E
RASE ALL PASSCODES soft button.
D) Reprogram passcodes as necessary; see To Create a Passcode on page 2-43.
The RESTORE DEFAULTS button (in the Restore
Defaults screen) restores
all System Setup and Input/Output parameters to their factory default
settings. It also erases all passcodes. You should never need to use this
button in an existing installation, although it is a convenient way to
make the 9400 “factory fresh” if it is being installed in a different facility.
The RESTORE DEFAULTS button takes you to a screen that allows you to
keep or erase any user presets that exist in your unit.