Specifications

Maxiva UAX
October 17, 2013
5‐11
888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.
Copyright©2013,HarrisBroadcast
Figure 5-6 FWD cable to REF PWR port with 20dB pad
Note
The RFLD Sample cable is removed and the FWD sample cable is connected to the REV input through a
20dB attenuator pad.
IfanattenuatorpadwasoriginallypresentontheREVinput,itshouldalsoberemovedalongwiththeREFLDsample
cable).
Ifanatte
nuatorwasoriginallypresentontheFWDinput,itshouldbemovedalongwiththeFWDsamplecableto
theREVinput.The20dBattenuatorcalledoutinthisprocedurewouldbeinadditiontoanyattenuatorpadalready
presentontheFWDsamplecable.
Note
REV (reverse) and RFLD (reflected are used here synonymously.
STEP 7 HighPointCalibration:Removethe20dBattenuatorusedintheprevious
stepandconnecttheFWDsamplecabledirectlytotheREFinput.Pressthe
Savebuttontostorethevalueinmemory.RefertoFigure5‐7onpa
ge5‐12.