Specifications

Maxiva UAX
October 17, 2013
5‐57
888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.
Copyright©2013,HarrisBroadcast
Figure 5-43 Signal Processor Board Connections
STEP 6
Usea#2PhillipsscrewdrivertoremovetheLPUtopcover(6screws).
STEP 7 Usea#1PhillipsscrewdrivertoremovetheT2901‐0215‐155Gexpansion
boardifpresent(6screws).Ifthereisnoexpansionboardremovetheclear
Lexancoverandretainforreuse.
STEP 8 RemovethreeribboncablesthatareconnectedtoJ23,J24&J25onthesides
andfrontofthesignalprocessorboard.
STEP 9 Removetheri bboncableconnectedtoJ18andtheRJ45cableconnectedto
J20onthefrontofthesignalprocessorboard.
STEP 10 RemovetheOSXRFcablesfromconnectorsJ13,J14,J15,J16,J17,&J19near
thefrontofthesignalprocessorboard.Thesecableconnectorscanbepulled
outoftheboardconnectors.
STEP 11 RemovetheOSXRFcablesfromconnectorsJ2,J3,J26,&J27attherearof
thesignalprocessorboard.Thesecableconnectorscanbepulledoutofthe
boardconnectors.