Specifications

Maxiva UAX

October 17, 2013

5‐75

888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.

5.11.0.1 AmpControlBoardS1Settings

RefertoFigure2‐9onpage2‐14forPABlocations.

5.11.0.2 AmpControlBoardS2Setting

TheswitchS2ontheLPUampcontrolboardisshowninFigure5‐58onpage5‐74.SwitchS2onthePABampcontrol

boardisshowninFigure5‐56onpa

ge5‐73.InallcasestheproperswitchpositionistowardJ2.

5.11.0.3 AmpControlBoardJumperSettings

TheampcontrolboardsintheLPUandinPABunitscontainjumpersJP1andJP2whichmustbesettoposition2‐3to

operateproperly.SeeFigure5‐56onpa

ge5‐73andFigure5‐58onpage5‐74forjumperlocations.

5.12 Hand ling

5.12.1 Storage

Thetransmitterandanysparesmustbestoredwithinthefollowingambienttemperatureandrelative

humiditylimits:

• Ambienttemperature:‐20...+70

• Relativehumidity:10...80%

5.12.2 Transport

WerecommendthattheUAXtransmitterbeshippedintheoriginalpackagingorinanadequateshock‐

proofcontainer.ThePABandLPUamplifierchassisshouldbeshippedwithallPAmodulesremovedand

packagedseparately.ThiswillpreventdamagetothePAmodulesocketsduringshipment.ThePS

modulesshouldbesecur

edintheirnormaloperationalpositions.

5.12.3 Disposal

Theunitmustbeproperlyrecycledordisposedofaccordingtonationaldisposalregulations.We

recommendconsultationwiththelocalauthoritiesforfurtherinformationaboutrecyclingordisposalof

theequipment.

Table5‐2S1SettingsonAmpControlBoards

S1Position Component

1 LPU

2 PAB1

3 PAB2

4 PAB3

5 PAB4