Specifications

Section-2 Installation
October 17, 2013
2‐10
Copyright©2013,HarrisBroadcast
WARNING:Disconnectprimarypower priortoservicing. 888‐2693‐004
UPSmainsdisconnect:connectthecontrolwiresforaUPSinhibitsignaltopins1&2onatTB2(undermetalpanel
ontopofcabinet).
Safetyin
terlock:IfacompleteACmainsinterruptionisnotdesired,routethesafetyinterlockloopdiscussedabove
throughtopins2&3onatJ2(interlockconnectorontopofcabinet)..
STEP 4
Procedurecomplete.
2.9.5 ProgramandReferenceConnections
Connecttheprograminputsandanyfrequencyreferencesignalstothetransmitter.Theseconnectionsaremadeat
therearpaneloftheLPUinacustomer‐suppliedrackoratthetopofthetransmitterrackifrackintegrationhas
beenprovided.
STEP 1
ConnecttheETI,ASI,SMPTE,oranalogaudio&videoinputs(asapplicable)
totheconnectionpointsshowninFigure2‐4.
Figure 2-4 Program and Frequency Reference Inputs (Cabinet I/O Panel )
Figure 2-5 Program and Frequency Reference Inputs (LPU I/O Panel )