Specifications

Maxiva UAX
October 17, 2013
2‐21
888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.
Copyright©2013,HarrisBroadcast
2.13 ConnectingviaIP/Ethernet
TheUAXtransmittermaybeaccessedbyacomputerviaEthernetforsetup,operation,andsoftwaredownloads.
ThisconnectionistypicallymadetotheLPU,butmayalso bemadetotheTCUindualdriveconfigurations.
Note
As of this printing, Harris recommends Firefox browser for use with this transmitter.
2.13.1 LPUAccessviaEthernet
TheLPUmaybeaccessedviatwodifferentEthernetports.
Thefr
ontRJ45connector,accessiblefromthefrontpanelbyremovingtheLPUfrontpanel,hasafixedIPaddressof
192.168.117.88andisdesignedfor1:1connectionstoapersonalcom puter.ItcontainsaninternalDHCPserverthat
willdirectaDHCP‐enabledpersonalcomputertoautomaticallyassumeacompatibleIPad
dressonitsend.
Note
The IP address on the PC end will be 192.168.117.yyy, where yyy ranges from 129 to 135.
Caution
DO NOT CONNECT THE LPU’S FRONT RJ45 CONNECTOR TO AN EXISTING
NETWORK BECAUSE THE DHCP SERVER IN THE LPU WILL CONFLICT WITH
THE DHCP SERVER IN THE NETWORK.
Ifthecomputerbeinguseddoesnotauto‐detectforcrossconnection,acrossovercablemustbeusedtoconnect
theLPUfrontEthernetporttothecomputer.
Table2‐14Control1J3(topofcabinet)
12 Pin Female (Active Low)
Signal, Digital/Analog
1
GND
2
TRANSMITTERON
3
TRANSMITTEROFF
4
RAISEPOWER
5
LOWERPOWER
6
RFMUTE
7
GND
8
SELECTDRIVEA
9
SELECTDRIVEB
10
SELECTAUTODRIVECONTROL
11
SELECTMANUALDRIVECONTROL
12
GND