Specifications

Maxiva UAX
October 17, 2013
3‐15
888‐2693‐004 WARNING:Disconnectprimarypower priortoservicing.
Copyright©2013,HarrisBroadcast
3.5.3.1 RaisingorLoweringOutputPower
Thepre‐filteraverageoutputpoweroftheUAXinwatts(W)isdisplayednumericallyandonabargraphatthetopof
everywebscreen.Powerfordigitalmodulationisgiveninaveragepower.Powerforanalogsystemsisgiveninpeak
ofsyncoutputpower.
STEP 1
UAXoutputpowerissetbyclickinginthewhiteFwdPwrReferencebox
(field)onConfigurationscreen1.RefertoFigure3‐13onpa
ge3‐13onleft.
STEP 2 Cleartheoldpowersetting.
STEP 3 Typethenewvalueforforwardpowerinwatts.
a.
Theoutputpowercanbesetbetween0andthevaluesetinNominalPowerOut‐
put(W)
.Maximumpowerwillvarydependingontransmittermodelnumber.
STEP 4
PressEntertoactivatethenewpowersetting.
Note
Note that output power is limited by the value in the Nominal Power Output (W) field. If you are unable to
raise the power above a certain point this setting should be checked.
STEP 5 Endofprocedure.
3.5.3.2 ReflectedPower
TheaveragesystemreflectedpoweroftheUAXinwatts(W)isdisplayednumericallyandonabargraphatthetop
ofeverywebscreen.Iffoldbackpowerreductionisactiveduetoexcessivereversepoweratthetransmitteroutput,
thereflectedbargraphwillbeyellow.Reflectedpowerfoldbacksett
ingscanbechangedonConfigurationscreen2
shownontherightinFigure3‐13onpage3‐13.
3.5.4 TCUSystemNetworkScreen
Figure 3-14 TCU Network Screen