Specifications

19
MAKING COPIES
Interrupt
INTERRUPTING A COPY RUN
INTERRUPT can be used to temporarily stop a long copy run so that
another job can be run.
●
Reduction/enlargement/zoom, exposure adjustments, dual page
copying, edge erase, and margin shift can be selected during
interrupt copying.
●
Duplex copying, sort, group, and staple sort cannot be selected
during interrupt copying.
●
INTERRUPT will not function during duplex copying or when an
optional auditor (SF-EA12) is used and the copier has been
programmed in the auditing mode.
Interrupting a copy run
1
Press the INTERRUPT key.
●
The copier will return to the initial settings.
●
If this copier has been programmed in the auditing mode using
auditing program No.10, “––” will appear in the copy quantity
display. Enter your account number using the 10-key pad. The
number of copies of the interrupt copying will be accumulated
against this account number. See page 8.
●
When an optional document feeder (ADF or RADF) is being
used, the copier will stop after completing the copying of the
originals which have been fed into the document feeder.
2
When the copier stops, remove the original(s) and place
the original for interrupt copying on the document
glass. Close the document cover.
●
If an optional document feeder (ADF or RADF) is installed, place
the originals face up in the document feeder tray.
3
Select the desired available copier functions.
4
Press the START key.
5
When the interrupt copy run is complete, press the
INTERRUPT key again to cancel the mode and remove
the original(s) used for interrupt copying.
●
The copier will reset itself to the functions which were in use
before the INTERRUPT key was first pressed.
6
Replace the original(s) for the interrupted job and press
the START key to resume copying.
INTERRUPT
CLEAR ALL
9
START
INTERRUPT
CLEAR ALL
Downloaded From ManualsPrinter.com Manuals