User manual

14
Before Using the Handset
SH-01H_E_02.fm
[14/28]
■ Inserting docomo nano UIM card
1
Open the docomo nano UIM card/microSD Card
slot cover
: Hook the tip of a finger into the slot and pull out it forward
(1), and then rotate it in the direction of the arrow to open
(2).
2
Remove the tray from the docomo nano UIM
card slot
: Hook the tip of a finger into the tray to remove it by slowly
pulling it straight out.
3
Hold the docomo nano UIM card with the IC
(gold) side turned up and set it on the tray
4
Insert the tray slowly into the docomo nano UIM
card slot
: The docomo nano UIM card slot is at the right side of the
microSD Card slot. When you insert the tray, be careful not
to insert it to the microSD Card slot.
: Do not forcibly insert the tray at an angle or with the wrong
side up. The docomo nano UIM card slot or tray may be
damaged.
5
Close the docomo nano UIM card/microSD Card
slot cover
: Stow the joint of the docomo nano UIM card/microSD Card
slot cover (1) and push the cover in the direction of the
arrow to close it so that gaps are not left between the
handset and the cover (2). When closing it, push securely
like tracing it from A areas to the joint (3).
■ Removing docomo nano UIM card
1
Open the docomo nano UIM card/microSD Card
slot cover
2
Remove the tray from the docomo nano UIM
card slot
3
Remove the docomo nano UIM card from the
tray
4
Insert the tray slowly into the docomo nano UIM
card slot
5
Close the docomo nano UIM card/microSD Card
slot cover
Slot
Notch
IC (gold)
docomo nano UIM card slot (right side)
Do not allow the docomo nano UIM card or tray to fall when
removing them.
Make sure not to touch or damage the IC (gold) of the docomo
nano UIM card when handling it. Also, note that inserting or
removing the docomo nano UIM card forcibly may damage it or
deform the tray.
Refer to the docomo nano UIM card user's guide for more
information on the docomo nano UIM card.
Do not misplace the docomo nano UIM card once it is removed.
IMEI plate
A plate on which the IMEI number (International Mobile
Equipment Identifier) is printed is stowed near the microSD
Card slot. The IMEI number is required when you contact a
repair counter that DOCOMO specifies, so do not pull it out.
Note that pulling out the IMEI plate forcibly or adding forces on
it may damage the plate.
If you accidentally pull out the IMEI plate, slowly return the IMEI
plate to the original position while taking care not to insert it too
deep.
Joint
SH-01H_E.book 14 ページ ２０１５年１０月３０日 金曜日 午後４時２２分