Service manual

14
SJ-D30M
SJ-D33M
(2)-4 Set Fan clamp to Propeller fan 100 and insert
it to the shaft of Fan motor.
(2)-2 Insert the terminals of Lead EV-cover ass'y to
Fan motor.
(2)-3 Fix two Motor cushions to Fan motor, and set it
at Fan motor holder A and B.
Then fix with Tapping screw.
Figure A-8
(3) Setting of Fan motor ass'y , Defrost thermo. ass'y and Fuse ass'y.
Fan motor
holder A
Fan motor
holder B
Motor cushion
Tapping
screw
Fan motor
Lead EV-cover ass’y
RED
BROWN
Figure A-10
[front side]
more than 3.5mm more than 3.5mm
L-band C
Defrost thermo.
ass’y
CUT
Not come out of claw.
10 5mm
+
SEC. F F
SEC. Z Z
Detail of G
Tapping screw
Tapping
screw
L-band C
Defrost thermo.
Set metal side below
AL tape
AL tape
AL tape
AL tape
E.v cover
sealer A
E.v cover
sealer C
20
25
25
Fuse ass’y
Lead e.v cover
ass’y
[back side]
F
G
F
C-insu sealer drr
25
C-insu sealer drr
30
Z
Z
40
AL tape
20
Fuse ass’y
Figure A-9
Fan clamp
Propeller
fan 100
Fan clamp
Slit
Slit of each Fan clamp
and Propeller fan
should not be at same position.
Shaft
4 0.5mm
+
Detail of D
D
Note
Propeller fan should not be
taken out from shaft when
pulled by 3 kgf.
Fan clamp
Propeller fan