Service manual

SJ-D30M

SJ-D33M

(3) Installing of Evaporator

(3)-1. Install Evaporator as shown in Fig. A-15 in the

reverse order of Fig. A-16.

(3)-2. Correct the deformed fin.

NOTE

1. When installing Evaporator, take care not to

deform significantly and break the pipes.

2. Take care not to damage the lead wires and hurt

yourself by the fin of Evaporator.

Fig. A-24

(2)-9. Set the assembly above on the food liner by fixing

a protrusion.

Fig. A-23

(2)-8. Set Heater cover on Drain support, and bend top

edge c and d to outside as shown in Fig. A-24.

(2)-6. Bend a and b of Drain support al to right angle

(90˚) to set Def. heater ass'y. (Fig. A-22)

Fig. A-21

(2)-4. Replace Def. heater ass'y with new one. (2)-7. Stick the longer wire to the Drain support by

aluminum tape (2 pieces), and wind vinyl tape

(2 pieces) to lead wires of Def. heater ass'y by

aluminum tape as shown in Fig. A-23.

Fig. A-22

Heater cover

Def.heater ass’y

Drain support al

This side is longer wire

This side is shorter wire

Def.heater ass’y

aluminum tape

[back side]

[bottom side]

Sec. AA

(W25 X L40)

top edge

Drain support al

Heater cover

Def.heater ass’y

Sec. BB