Owners Manual
13
Notes:
1 Bolt 3 Handle screw
2 Bolt hole 4 Screw hole cap
ADJUSTING THE SHELVES
The cantilever rack could be adjusted to the proper height as
required by food.
• To adjust the cantilever rack please follow the arrows as
shown in Figure 20.
• Raise it upward rst and then take it out by tilting it upward.
• During installation, put the upper end of the xed leg into
one of the upper slots on the supporting iron rst and then put
the lower end of the xed leg into the third slot on the lower
part of the supporting iron.
Slot
Upper end
of fixed leg
Lower end
of fixed leg
1
2
3
Figure 20
BEFORE USING THE REFRIGERATOR
• Before use, remove all packing materials, including bottom
cushions, foam pads and tape inside of the refrigerator; tear
off the protective lm on the doors and the refrigerator body.
• Before turning the refrigerator on, keep the refrigerator still
for 2 hours before connecting it to power supply.
INSTALLATION INSTRUCTIONS
• Before putting any fresh or frozen foods, the refrigerator
should have run for 2-3 hours or for about 4 hours in summer
when the ambient temperature is high.
ENERGY SAVING TIPS
• The appliance should be located in the coolest area of the
room, away from heat producing appliances or heating ducts,
and out of the direct sunlight.
• Let hot foods cool down to the room temperature before
placing in the appliance. Overloading the appliance forces
the compressor to run longer. Foods that freeze too slowly
may lose quality or spoil.
• Be sure to wrap foods properly and wipe containers dry
before placing them in the appliance. This cuts down on frost
build-up inside the appliance.
• Appliance storage bin should not be lined with aluminum
foil, wax paper or paper toweling. Liners interfere with cold
air circulation, making the appliance less efcient.
• Organize and label food to reduce door openings and extended
searches. Remove as many items as needed at one time, and
close the door as soon as possible.