Shark Easy Spray™ Steam SK115 OWNER’S GUIDE WWW.SHARKCLEAN.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK® Easy Spray™ STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK® EASY SPRAY™ STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the openings is very hot. POLARIZED PLUG: This appliance has a polarized plug (one blade is wider than the other).
12. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 13. DO NOT put any objects into openings. Do not use with any opening blocked. 14. DO NOT put hands or feet under the steam mop. Unit gets very hot. 15. Use ONLY on flat, stable horizontal surfaces. Do not use on walls, counters, windows, chairs or tables. 16.
Thank you for purchasing the Shark® Easy Spray™ Steam Mop. This Owner’s Guide is designed to help you get a complete understanding of your new steam mop. Please read it carefully and keep for future reference. For a list of what is included with this model, refer to inside flap of box. If you should have a question about your Shark® Easy Spray™ Steam Mop, please call the Shark® Customer service line at 800-798-7398. THIS BOOK COVERS MODEL NUMBER: SK115 11 REGISTER YOUR PURCHASE: www.sharkclean.com 800.
PA RT S When assembling your Shark® Easy SprayTM steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Easy SprayTM Steam Mop.
A ssembly fig. 1 fig. 2 YOUR SHARK® EASY SPRAY ™ STEAM MOP IS EASY TO ASSEMBLE 1 First remove all the parts from the package. We know you’re excited about the Shark® Easy Spray™ Steam Mop, but don’t plug it in until it’s fully assembled and you’ve read all of the following instructions. 2 Slide the upper extension tube (the tube with the handle) into the lower extension tube (the short tube). Push the two extension tubes together until you hear it click into place.
US E fig. 3 ATTACHING THE CLEANING PAD 1 Place the cleaning pad on the floor with the logo side facing up. Place the Easy Spray™ Steam Mop on the top of the pad to attach. (fig. 3) IMPORTANT: Only add water to the tank. Chemicals or cleaning solutions may be unsafe or cause damage. IMPORTANT: Please wait 3-5 minutes for your Easy Spray™ Steam Mop to cool off before removing the cleaning pad.
US E The water tank cap has an arrow to indicate the locked and unlocked position. fig. 4 FILLING THE WATER TANK IMPORTANT: Before you fill up the tank, make sure your Easy SprayTM Steam Mop is unplugged from the wall. 1 First, remove the water tank cap by turning it counter clockwise to the unlocked position. See illustration for a visual explanation. (fig.
US E Now comes the part you’ve been waiting for – it’s time to use your Easy Spray™ steam mop. When you use your steam mop for the first time or haven’t used the unit in awhile, it may take a minute or two for the water to make its way through the pump and into the heater to create steam. Get it started by pumping the handle a few times. If you’ve waited a few minutes and you still don’t see any steam, reference the troubleshooting section on page 8. fig.
US E When your Easy Spray™ Steam Mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime. fig. 7 fig. 6 2 Spray the Shark® Steam Energized™ Cleanser freely on the mess or stain you aim to clean. (fig. 6) 3 It takes about 30 seconds for the steam to get going. Now pump the handle a few times to prime the pump and activate steam. 4 Mop with a forward and backward motion to customize steam output automatically. (fig.
KEEPING YOUR CLEANING PAD AS GOOD AS NEW Your steam activated cleaning pad works wonders for you, so return the favor by giving it the care it deserves. 1 Wash pads in warm water. Wash separately from other laundry. Only use liquid detergent. (no powder detergent) Don’t use any fabric softeners. Line dry or dry on a low dryer setting. 2 If there are loose threads on the pad careful cut the thread with scissors. Don’t pull on them or cut at the base.
T R O UB L ESH OOTI NG PROBLEM POSSIBLE REASONS & SOLUTIONS The Easy Spray™ Steam Mop will not turn-on. Easy Spray™ Steam Mop will not make steam. Easy Spray™ Steam Mop leaves water on the floor. Easy Spray Steam Mop left white spot on the floor. Your steam-mop should be securely plugged into an electrical outlet only. Check your fuse or breaker. If your unit still doesn’t work, give us a call 1-800-798-7398. Is there water in the water tank? If not, add water to your Steam Mop following instructions.
AC C ES S O RI ES NOTE: Select cleaning accessories are included. Others are available for purchase at www.SharkClean. com or by calling 800.798.7398. For a list of what is included with this model, refer to inside flap of box. ACCESSORY Shark® Steam Energized™ Cleanser Combine Steam & Cleanser for a superior level of cleaning performance. XSTENER10 Washable Cleaning Pads Wipes out tough messes. Keeps cleaning room after room. Lasts up to 20 washes! Unique bumper design for enhanced edge cleaning.
Notes 10 TOLL FREE: 1-800-798-7398
ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid.
EURO-PRO Operating LLC U.S.: Canada: Newton, MA 02459 Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com COPYRIGHT © 2013 EURO-PRO OPERATING LLC PRINTED IN CHINA Euro-Pro, Shark, SaniFiber, Easy Spray and Rotator are trademarks of Euro-Pro Operating LLC. SK115.E.131223.1 Illustrations may differ from actual product.
