Use Care & Installation Guide

E 4
Shelf detail showing the deflector shield installed.
Shelf detail showing the deflector vent during installation.
Position deflector vent and mark holes. Pre drill using a
1
/16" (1.57 mm)
bit before mounting.
Front view
No oven
C
B
A
Suggested electrical
outlet location
Anti-Tip block
1 Sharp Plaza Suite 1, Mahwah, New Jersey 07495-1123, USA • 1-800-BE-SHARP (237-4277)
335 Britannia Road East, Mississauga, Ontario, L4Z 1W9, Canada
3. Place the drawer adjacent to the wall or cabinet opening. Plug
the power supply cord into the electrical outlet.
4. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and also pinching
the cord between the oven and the wall.
5. Slide the drawer all the way back until the mounting anges
touch the cleats mounted in the cabinet opening.
6. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a 1/16” (1.57 mm) bit. See Figure 4.
Figure 3A
Figure 4
Figure 3B
2. Install deector as shown in Figure 3A.
7. Secure the drawer with the 4 screws supplied.
Mounting
flange
Figure 2B
Figure 2C
3
/4" (19.05 mm)
shelf
Side view
1
3
/4" (44.45 mm)
front face of shelf
Front face of cabinet
16
7
/8"
(428.62 mm)
flush opening
height
Move oven location
downward for extended
countertops for better
viewing angle.
Anti-Tip
block
A. 28-7/16" (722.3 mm) mounting cleat opening width
B. 30-5/16" (769.92 mm) minimum
30-5/8" (777.87 mm) maximum
ush opening width
C. 3/4" (19.05 mm) shelf